Sony BDX-D1000 Bedienungsanleitung Seite 32

Menu Operations
Settings on the VIDEO CONTROL menu
You may specify the video output requirements on the
VIDEO CONTROL menu.
VIDEO CONTROL
VITC
VITC L1/L2
PACKET VBI
VIDEO INDEX
LUMIN.GAIN
CHROM.GAIN
COMPONENT
HUE
SETUP
SYNC PHASE
VITC: Application of VITC (USER VITC, USER
LTC, MPEG TC
VITC L1/L2: Line on which VITC is applied.
PACKET VBI: Application of VBI (AUTO
OFF)
VIDEO INDEX: Application of video index to the
SDI signal (ON or OFF)
LUMIN. GAIN: Gain for the luminance signal.
Set 000 to FFF hexadecimal.
Standard setting: 800.
CHROM. GAIN: Gain for the chrominance signal.
Set 000 to FFF in hexadecimal.
Standard setting: 800.
COMPONENT: Format of the component signals
(CCIR-601 or BETACAM) (applies only to video
signals in 525/60 mode)
HUE: Hue (–30° to +30° in steps of 1°)
SETUP: Setup (0 to 10 IRE in steps of 0.5 IRE)
(applies only to video signals in 525/60 mode)
SYNC PHASE: Sync phase, or the phase difference
in the range of 0x5ff to 0x9ff with the 13.5 MHz
clock (center value: 0x800).
A value over 0x800 means that the video signal
goes ahead of the reference signal.
.............................................................................................................................................................................................................................
1) MPEG TC: Displayed, but not used at present.
2) AUTO: To apply VITC or VBI to the output signal only
when the corresponding data is included in the input signal.
12 (E)
USER VITC
16/18
AUTO
ON
0x800
0x800
BETACAM
0 deg.
+ 0.0IRE
0x800
1)
, or OFF)
2)
Settings on the AUDIO CONTROL menu
You may specify the audio output requirements on the
AUDIO CONTROL menu.
AUDIO CONTROL
ADVANCE
CH1/2 GAIN
CH3/4 GAIN
CH5/6 GAIN
CH7/8 GAIN
RATE CONV.
ADVANCE: Advance with respect to the video
signal (+ µsec).
Press the ENTER button after setting.
or
CH1/2 GAIN to CH7/8 GAIN: Gain of the
corresponding channels.
The gain is fixed to 0 dB when receiving an
LPCM audio signal.
RATE CONV.: Sampling frequency conversion of
the AES/EBU digital audio output
AUTO: The sampling frequency of the output
audio signal is always 48 kHz in synchronization
with the output video signal.
OFF: The input audio signal is output as-is.
As a digital audio signal is output with no
frequency conversion, noise may occur at a device
on subsequent stages depending on the input
signal.
+0us
-0dB
-0dB
---
---
AUTO