Specifications - Makita BUH550 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Red part
1-2. Button
1-3. Battery cartridge
2-1. Switch trigger B
2-2. Switch trigger A
3-1. Adjusting dial
4-1. Hook
4-2. Belt
7-1. Trimming direction
7-2. Hedge surface to be trimmed
7-3. Tilt the blades.
8-1. String
12-1. Press
12-2. Chip receiver

SPECIFICATIONS

Strokes per minute (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for trimming hedges.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model BUH550
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.5 dB(A)
Model BUH650
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.5 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Explanation of general view
12-3. Nut
12-4. Shear blade
13-1. Nut
13-2. Branch catcher
14-1. Hooks
14-2. Fit the hooks into groove
14-3. Grooves
15-1. Press the hooks on both sides
15-2. Unlock the hooks
16-1. Blade cover
16-2. Screws
17-1. Under cover
17-2. Blade cover
18-1. Plate
Model
Blade length
-1
)
Overall length
Net weight
Rated voltage
) : 85.1 dB(A)
pA
) : 93.1 dB(A)
WA
) : 84.3 dB(A)
pA
) : 92.3 dB(A)
WA
BUH550
550 mm
1,070 mm
5.1 kg
ENE014-1
Model BUH550
Work mode : impact tightening of fasteners of the
ENG905-1
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model BUH650
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENG900-1 WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
5
19-1. Crank
20-1. Screws
20-2. Shear blade
21-1. Crank
22-1. Oval hole of shear blade
24-1. Oval hole of shear blade
24-2. Crank
25-1. Crank
26-1. Limit mark
27-1. Holder cap cover
27-2. Screwdriver
28-1. Brush holder cap
28-2. Screwdriver
BUH650
650 mm
1,000 - 1,800
1,150 mm
5.2 kg
D.C.36V
2
) : 2.5 m/s
h
2
2
) : 3.0 m/s
h
2
ENG901-1