15 5.1 Switching On And Off; Systemsoft Bea-Pc; 15 5.3 Operating The Bea-Pc Software; Maintenance - Bosch BEA 950 Originalbetriebsanleitung

5. Operation
5.1 Switching On and Off
Switch the BEA 950 with the "Premium" trolley on and
off using the central on/off switch on the front of unit
(see fig. 1, item 10).
Switch the BEA 950 with the "Medium" trolley on or off
with the central on/off switch on the rear of the unit
(see fig. 4; item 6).
i
Before switching off the device, shut down the com-
puter using the Windows operating system. Leave
the computer switched off for at least 60 seconds
before switching on again.
i
When operating the BEA 950, malfunctions can
occur if the computer or other components (e.g.
connecting cables) being used were not supplied by
Bosch.
5.2

SystemSoft BEA-PC

i
The current version of SystemSoft BEA-PC is inclu-
ded in the scope of delivery as a DVD. Installation is
described in the enclosed operating instructions for
BEA 055 and BEA 070.
5.3 Operating the BEA-PC software
The BEA-PC software is operated using the computer
keyboard, USB mouse or remote control.
i
Please note that the channel setting must always be
selected before operating the remote control. This
procedure is described in the enclosed operating
instructions.
5.4 Operation
!
Only carry BEA 070 in an upright position. If the
BEA 070 is tilted during transportation, condensate
may escape and damage the measurement chamber.
!
At an ambient temperature of >35 °C, no more than
20 pages can be printed in a one hour period.
Robert Bosch GmbH
6.

Maintenance

6.1 Cleaning
6.1.1

BEA 950

Only clean trolley and housing with soft workshop
rags and neutral cleaning agents. Do not use abrasive
cleaning agents and coarse workshop rags.
6.1.2 Data storage device
Clean DVD with a cleaning kit or wipe the silver side of
the data storage device carefully with a soft, lint-free
cotton cloth. Never use paper towels as these could
cause scratches.
6.1.3 DVD drive
Clean the DVD drive regularly with a cleaning data car-
rier for the DVD drive. The appropriate cleaning disks
are available from most computer or entertainment
electronics shops.
6.2 Calibration
For applications demanding mandatory calibration, re-
gular calibration is essential. (depending on the regula-
tions of the respective country).
6.3 Maintenance and
maintenance intervals
i
Routine maintenance ensures that the system is
always ready to use at all times. Maintenance can
be performed by a maintenance service contractor
or by qualified personnel of the analyzer's owner;
the maintenance must be documented and must be
indicated on the measuring instrument.
For maintenance instructions, refer to the operating
instructions for BEA 055 and BEA 070 included in the
scope of delivery.
| BEA 950 | 21 en
1 689 989 441 | 2019-07-01