Sony DSBK-2020 Installationsanleitung Seite 29

6
Attach the connector panel supplied with this product as follows.
1) Pass the wiring harness through the special opening for this
connector panel, and connect to the connector panel (see
following figure 1).
2) To install in the DSR-2000A/2000AP, connect the i.LINK
(interface) harness removed in step 3 to the connector panel (see
following figure 2). (For installation in the DSR-2000/2000P,
the i.LINK harness connection is not required.)
3) Fasten the connector panel with screws (see following figure
3).
Harness
7
Pack away the ferrite core and harness as follows.
1) Fit the ferrite core alongside the HIF-34 board.
2) Take up the slack in the harness (CN201, CN202), and clip into
the cable holders A and B.
3) Take up the slack in the i.LINK harness, and clip into the cable
holder C and groove D in the black plastic component. (This
step 3) is not required when you install this board in the DSR-
2000/2000P.)
DSR-2000/2000P/2000A/2000AP
i.LINK harness
Supplied screw (silver-colored)
Connector panel
Installation 29