Siemens RWF50 Montage- Und Bedienungsanleitung Seite 16

Output power regulator code 20083339
 Code 20083339 should be installed with different methods
depending on the burner (L) or (M) in the bracket 1) sup-
plied, and fixed to it with the specific accessory 5).
Application on RS 34-44/E - RS 25-35/E burners
 Fix the bracket 1) (L) on the side of the burner using the
screws 4) (L) that have been supplied
Application on RS34-44/M - RS25-35/M burners
 Remove the cover of the pressure switch 2) (M) and loosen
the two fixing screws to get the space needed for taking out
the bracket 1) (M), connecting it to the screws themselves;
 During this operation, it is necessary to pass the thermostat
cable inside the slot 3) (M).
Electrical wiring:
– Connect the regulator plug to the socket on the burner.
Output power regulator code 20073595
For code 20073595 proceed as follows:
 Cut along the line highlighted in 1) (N);
 remove the covering plate 2) (N), levering it with a screw-
driver at the four points shown;
 Insert the regulator 3) (N) into the bracket of the burner and
fix it with the two screws 4) (N).
Electrical wiring:
– Connect the plug 5) (N) coming from the regulator to the rel-
ative socket 6) (N) of the burner.
Output power regulator code 20085417
For code 20085417 proceed as follows:
 Cut along the line highlighted in 1) (O);
 remove the covering plate 2) (O), levering it with a screw-
driver at the four points shown;
 Insert the regulator 3) (O) into the bracket of the burner and
fix it with the two screws 4) (O).
Electrical wiring:
– connect the plug 5) (O) coming from the regulator to the rel-
ative socket 6) (O) of the burner.
The manufacturer declines all responsibility for
modifications or connections different from those
shown in these diagrams.
WARNING
After carrying out maintenance, cleaning or
checking operations, reassemble the cover and
all the safety and protection devices of the burner.
20106351
Output power regulator
G + (max 30 mA)
G - (max 30 mA)
WARNING
16 GB
RWF 40 ...
L1
N
Q13
Q14
Q
Y1
Y2
Q63
Q64
X1+
X1-
G1+
I1
M1
U1
XB6
M6
B9
M9
D1
D2
GND
(*)
No default configuration. Should be configured
as Function "D1" or "D2".
See specific manual for programming the param-
eters.
RWF 50.2 ...
L1
N
1N
1P
KQ
K2
K3
----------------------------
----------------------------
----------------------------
----------------------------
11
12
13
11
----------------------------
----------------------------
----------------------------
----------------------------
(*)
D1
----------------------------
DG
G + (max 25 mA)
G - (max 25 mA)
Tab. A