Operator's Display Replacement; When Fixing Parts That Use Vesa Mounts Are Not Installed - Panasonic JS-970 Series Handbuch

Operator's Display Replacement

Be sure to disconnect the power cable of the main block (POS Workstation) and
confirm the power is "OFF" before the operation below.

■ When fixing parts that use VESA mounts are not installed

1
Follow step 1 in "AC Adapter Installation" to remove
the cable cover. (
2
Loosen two thumbscrews securing the main block
and the operator's display.
● Loosen the thumbscrews until they are extended
by their springs.
● If you continue to loosen the thumbscrews further
after they are extended, they could become
detached. Make sure not to detach them.
3
Hold both sides of the display unit and slowly
separate the main block from the operator's display.
page 28)
Thumbscrews
37