General Guidelines - Velleman PSI300SB Bedienungsanleitung

Caution: Device heats up during use. Never cover the device and
keep the ventilation slots free from dust and obstructions at all
times.
Do not use near inflammable products or in explosive atmospheres.
Heat can cause fire to inflammable products even when they are
not in sight.
Keep this device away from children and unauthorized users.
Keep this device away form rain, moisture, splashing and dripping
liquids, oils, grease and inflammable products.
There are no user-serviceable parts inside the device. Refer to an
authorized dealer for service and/or spare parts.
3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages
of this manual.
Keep this device away from dust and extreme heat. Install the
inverter in a well-ventilated place. Do not expose the inverter
to direct sunshine or heat sources.
Protect this device from shocks and abuse. Avoid brute force
when operating the device.
Familiarise yourself with the functions of the device before actually
using it.
All modifications of the device are forbidden for safety reasons. Damage
caused by user modifications to the device is not covered by the
warranty.
Only use the device for its intended purpose. Using the device in an
unauthorised way will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not
covered by the warranty and the dealer will not accept responsibility for
any ensuing defects or problems.
Make sure the batteries are completely charged. A low battery voltage
will be indicated by the red LED to light and a sound signal. In this case,
disconnect the inverter from the battery and charge the battery.
Always switch off the inverter when starting the car or van. Starting the
car will cause the battery to produce a peak voltage which can be harmful
to the inverter.
The inverter is internally protected. Only replace the fuse with an
identical fuse.
The inverter will cut off the output in case of technical problems. Switch
off the inverter immediately and break off all connections. Check the
connected device.
Let the inverter cool down after a prolonged or heavy use.
In case of an overload, the auto-restart function will automatically switch
on the inverter as soon as the overload has disappeared.
V. 02 – 17/05/2013
PSI300SB/PSI300SS
3 ©Velleman nv