Velleman PIR416 Bedienungsanleitung Seite 4

• Damage cau used by disregard of c
is not covere
responsibilit ty for any ensuing def
4. Installati
Refer to the illu
The in
1. Choose a pr roper location for the s
temperature e changes frequently,
heating dev
detection fie eld of the sensor to pr
2. The PIR sen
12 mm in di
side of the w wall, inside a dropped
Leave suffic
ventilation.
Notes:
• The lead wir
the controlle er on the other side of
12 mm for t the connector and wir
• Make sure t
inside a dro
be sufficient
3. A 12 Vdc/2.
4. Connect the e sensor to the control
one way, do o not force.
5. Set the DIP
ligh ht sensitivity
mo ovement sensitivity
5" On
30" On
1' On
3' On
5' On
8' On
Note: only the e highest selected on-t
V. 02 – 03/10/ /2012
ed by the warranty an
on
ustrations on page 2 o
stallation must be car
ices. Also avoid movin
sor must be installed
iameter. The controlle
ient space (at least 2
res of the sensor are ±
he controller is access
pped ceiling or behind
tly protected to avoid
6 A power supply (no
switches [3]:
-time
time
-time
-time
-time
-time
PIR4 416
certain guidelines in th
nd the dealer will not
fects or problems.
of this manual.
rried out by a qualified
sensor. Avoid places w
e.g. near air conditio
ng obstructions or obj
revent unnecessary ac
inside a hole which is
er can be installed on
ceiling or, behind a fa
cm) around the contr
± 20 cm long. When m
f a wall, drill a hole of
es to go through.
sible at all times when
d a false wall. Howeve
accidental touching!
t incl.) must be provid
ller [2]. The connecto
ON
< 10 lx
low
5 seconds
30 seconds
1 minute
3 minutes
5 minutes
8 minutes
time will be applicable
4
his manual
accept
d person.
where
ners or
jects in the
ctivation.
s max.
the other
alse wall.
roller for
mounting
f at least
n installing
er, it should
ded.
or fits only
OFF
always
high
-
-
-
-
-
-
e.
© ©Velleman nv