Velleman CAMSET20 Bedienungsanleitung Seite 4

display/ handset
A LCD display
B display ON/OFF button
C door unlock button
D warning button
camera/doorbell
J speaker
K camera
L IR LEDs
wiring
1 yellow video
2 black ground
6. Installation
Camera/doorbell
• Choose a location for the camera/doorbell. Refer to the drawing on page 2 of this
manual for the detection range of the camera (left drawing: side view, right
drawing top view). Avoid pointing the camera towards direct sunlight or bright
surfaces.
• The camera/doorbell unit has two connection cables, a 4-wire monitor cable to
connect the camera/doorbell with the display/handset and a 2-wire cable which
can be used to trigger an automatic lock release mechanism (not incl.).
Note: the maximum load of the automatic release contact is 1KΩ.
• Make a hole in the wall and guide the cable coming from the monitor (and
automatic release lock when applicable) through.
• Place the sunshield over that hole and mark the mounting hole locations.
• Drill two mounting holes (Ø6mm) and insert the included screw anchors.
• Place the sunshield on the back of the camera unit (cables go through).
• Connect the 4-pins connector with the cable coming from the display/handset.
When applicable, connect the 2-pins connector with the cable from the lock release
mechanism (not incl.).
• Screw the camera/doorbell unit with sunshield onto the wall with the included
screws. Close the screw holes with the included plastic caps. Note that the flat cap
goes into the upper screw hole, the angled cap in the lower.
Display/handset
• Choose a location for the display/handset. Note that the included cable is 10m
long.
• Make a hole in the wall and guide the monitor cable through. Note that the back of
the handset has slots at the top and at the bottom to guide the cable through
when drilling through the wall is no option.
• Attach the handset to the wall with the included mounting bracket. Use the bracket
to mark the mounting hole locations. Refer to the drawing on page 2 for the
correct mounting direction of the bracket (arrow indicates top).
• Drill two mounting holes (Ø6mm) and insert the included screw anchors.
• Screw the mounting bracket on the wall with the included screws.
• Connect the leads of the monitor cable. Refer to the drawing on page 2 and §5 for
connection details.
• Connect the plug of the power adaptor to the jack at the back of the handset as
indicated in the drawing on page 2 of this manual.
• Position the display/handset unit over the mounting bracket and slide it down to
secure it.
• Plug the power adaptor in the mains. The system is now ready for use.
01 (19/11/2008)
CAMSET20
E status LED
F luminance adjustment button
G contrast adjustment button
H hue adjustment button
I volume control switch
M doorbell button
N microphone
O light sensor
3 red power
4 white audio
4
®
Velleman