Specifications - Makita AT450H Betriebsanleitung

ENGLISH (Original instructions)
1. Safety glasses
2. Face shield
3. Contact element
4. Trigger
5. Workpiece
6. Compressor air output per minute
7. Nailing frequency
8. Adjuster
9. Deep
10. Shallow

SPECIFICATIONS

Applicable staples
Staple capacity
Min. hose diameter
Pneumatic tool oil
Dimensions (L X H X W)
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
....... Read instruction manual.
.......... Wear safety glasses.
.................... Do not use on scaffoldings, ladders.
Intended use
The tool is intended for pressing staples into construction
materials such as timbers.
Pneumatic nailer/stapler safety
warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in serious injury, electric shock
and/or fire.
Save all warnings and
instructions for future reference.
For personal safety and proper operation and
maintenance of the tool, read this instruction manual
before using the tool.
6
Explanation of general view
11. Too deep
12. Flush
13. Too shallow
14. Screw
15. Hook
16. Groove
17. Protrusion
18. Flat nose adapter
19. Staple stopper
20. Pusher base
Model
Air pressure
Net weight
General safety
END106-3
• Do not permit those uninstructed to use the tool.
• No horseplay. Respect the tool as a working
implement.
• Do not operate when under the influence of alcohol,
drugs or the like.
• Never alter the tool.
Personal protective equipments
• Always wear safety glasses to protect your eyes from
dust or fastener injury.
WARNING: It is an employer's responsibility to
enforce the use of safety eye protection equipment by
ENE054-1
the tool operators and by other persons in the
immediate working area.
For Australia and New Zealand only
Always wear safety glasses and face shield to protect
your eyes from dust or fastener injury. The safety
glasses and the face shield should conform with the
ENB109-5
requirements of AS/NZS 1336. (Fig. 1)
• Wear hearing protection to protect your ears against
exhaust noise and head protection. Also wear light but
not loose clothing. Sleeves should be buttoned or
rolled up. No necktie should be worn.
Work area safety
• Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
• Do not operate the tool in explosive atmospheres, such
as in the presence of flammable liquids, gases or dust.
Operating the tool can create sparks which may ignite
the dust or fumes.
21. Pusher
22. Change lever
23. Exhaust cover
24. Exhaust vent
25. Hex wrench
26. Front guide
27. Contact top
28. Drain cock
29. Thinner
30. Stove
AT450H
1.28 - 2.26 MPa (12.8 - 22.6 bar)
25 mm - 50 mm
84 pcs. (1 strip), max. 105 pcs.
5.0 mm
ISO VG32 or equivalent
261 mm X 115 mm X 269 mm
1.5 kg