Cleaning And Care; Troubleshooting; Disposal Considerations; Declaration Of Conformity - Klarstein 10028310 Handbuch

You must DISCONNECT the appliance from the electricity supply, before you can carry out any
cleaning or maintenance work.
• External cleaning: Use only soap and water and then dry tho-
roughly. Do not use methylated spirit,diluents or similar products.
• Cleaning the door: Clean periodically the interior part of the door
to remove any fl uff . Accurate cleaning ensures correct drying.
• Cleaning the fi lter: Your dryer will only function well if the
fi lter is clean. The fi lter collects all the fl uff which accumula-
tes during drying and they must therefore be cleaned at the
end of each programme, before removing the laundry, with a
damp cloth.
Malfunction
Dryer does not work.
Drying results
unsatisfactory.
Drum light does not work
Drying cycle ends shortly
after programme starts.
Drying cycle lasts an
unusually long time.
Disposal and Declaration of Conformity
According to the European waste regulation 2002/96/EC this symbol on the product
or on its packaging indicates that this product may not be treated as household was-
te. Instead it should be taken to the appropriate collection point for the recycling of
electrical and electronic equipment. By ensuring this product is disposed of correct-
ly, you will help prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate waste handling of
this product. For more detailled information about recycling of this product, please
contact your local council or your household waste disposial service.
Producer: CHAL-TEC GmbH, Wallstraße 16, 10179 Berlin.
This product is conform to the following European Directives:
2014/30/EU (EMC)
2014/35/EU (LVD)
2011/65/EU (RoHS)
19

Cleaning and Care

Troubleshooting

Possible cause
Main plug is not plugged in.
Loading door is open.
Start button hasn't been pressed. Press the Start button again.
Wrong programme selected.
Filter clogged.
Incorrect volume of laundry.
The sediment on humidity sensor. Washed humidity sensor surface.
Light bulb is defective.
Not enough washing loaded.
Washing loaded is too dry for
selected programme.
Load volume is too big.
Solution
Plug in all main sockets.
Close loading door.
Select a diff erent programme the
next time you dry.
Clean lint fi lter.
Observe recommended loading
volumes.
Replace light bulb.
Load more washing.
Select higher lower level
(e.g. Heavy instead of Strong)
Reduce load volume