Hama 00054221 Kurzanleitung Seite 8

• Use the fastening tab to pull the drive belt on the
underside of the turntable over the drive roller of the
motor.
Ribbon
• Remove the attachment tab.
4.2 Turntable mat
• Place the included turntable mat in the centre of the
turntable.
4.3 Removing the protective cap from the stylus
Note
• The protective cap protects the stylus from dust and
other soiling.
• Before starting playback or recording, remove the
protective cap from the stylus.
• When finished using the record player, replace the
protective cap on the stylus.
• Do not touch the stylus with your hands. Doing so
may cause damage.
• Pull the protective cap off of the stylus (A) of the tone
arm (B) by pulling it forward.
4.4 Tone arm clip for safe transportation
Note
• The tone arm is secured for transport with a clip.
• Remove the clip before use.
• Secure the tone arm before moving the device to
protect it from damage.
4
Removing the transport safety
• Remove the clip from the tone arm. It is located directly
• Now the tone arm (7) can be removed from the tone
Belt
Attaching the transport safety
• Place the tone arm (7) on the tone arm rest (6).
• Attach the clip to the tone arm.
Motor Pully
4.5 Adjusting the tone arm (zero balancing)
The tone arm must always be balanced. It should move
horizontally over the turntable only. Adjust the tone arm to
correct any tipping forwards or backwards.
• Remove the protective cap as described in section 4.3
• Remove the tone arm (7) from the tone arm rest (6).
• Turn the counterweight (4) clockwise or anticlockwise to
• Set the tone arm (7) back on the tone arm rest (6).
4.6 Adjusting the pressure on the stylus
• The ideal pressure on the stylus for the included
• The balancing ring moves together with the
• Remove the protective cap as described in section 4.3
• Remove the tone arm (7) from the tone arm rest (6).
• Turn the counterweight clockwise to increase the stylus
• Set the tone arm (7) back on the tone arm rest (6).
at the tone arm rest (6).
arm rest.
Removing the protective cap from the stylus.
move it until the tone arm (7) is level over the turntable.
Note
pickup system is 3.5 grams.
counterweight when it is turned. Thus you should
check the stylus pressure before each use.
Removing the protective cap from the stylus.
pressure or anticlockwise to decrease it.
Balancing ring