Ec Declaration Of Conformity; Maintenance - Makita 6706D Betriebsanleitung

NOTE:
• Always tighten the two screws to secure the adjust-
ing ring after adjusting the fastening torque.
• The fastening torque may differ depending upon the
kind of screws, the type of materials to be fastened,
etc. Before starting your job, always perform a test
operation to verify the adequate fastening torque.
Operation
The proper fastening torque may differ depending
upon the kind or size of screws, the type of materials
to be fastened, the condition of the threads, etc.
Before starting your job, always perform a test opera-
tion to verify adequate fastening torque. Hold the tool
firmly with both hands whenever possible and place
the socket over the bolt or nut. Then turn the tool on.
As soon as the bolt or nut becomes tight, the clutch
will cut in and the motor will stop automatically.
Release the switch trigger.
When fastening tool screws, use the proper screw-
driver bit shown in Fig. 7. It is commonly available on
the market.
For 6706D and 6706DW
When the battery capacity decreases to a certain
level, the motor will not start even if you press the
switch trigger. This mechanism prevents poor fasten-
ing caused by battery voltage-drop. Charge the bat-
tery cartridge to resume operation.
NOTE:
• Always use the correct size socket for bolts and
nuts. An incorrect size socket will result in inaccu-
rate and inconsistent fastening torque and/or dam-
age to the bolt or nut.
• Hold the tool with its square drive pointed straight at
the bolt or nut, or the bolt or nut will be damaged.
• If the motor will not start even after you pull the trig-
ger, release the trigger. Then pull the trigger again
after turning the socket slightly with your fingers.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out any
work on the tool.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by
a Makita Authorized Service Center.
For European countries only
Noise and Vibration
The typical A-weighted sound pressure level is not more
than 70 dB (A).
The noise level under working may exceed 85 dB (A).
– Wear ear protection. –
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN60745.
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product
is in compliance with the following standards of standard-
ized documents,
EN60745, EN55014
in accordance with Council Directives, 89/336/EEC and
98/37/EC.
Yasuhiko Kanzaki
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes,
Bucks MK15 8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan
2
.
CE 2005
Director
ENG001-2
ENH102-4
7