Operation - Velleman CCTVPROM11 Schnelleinstieg

User profile selection
•
It is possible to log on to the system as administrator (
status bar.
•
Switch between user profiles by clicking on the icon (
•
Click on the lock-icon
Video output
• On both VGA and monitor outputs the video signal is present simultaneously.
• To switch to the other display, go to ADVANCED CONFIG and set the DISPLAY OUTPUT PATH.
Note: the DVR must be reset for the setting to take effect.
• It is also possible to select a display at start-up of the DVR. Press the left key (
during start-up to use the CRT monitor; press the right key (

8. Operation

Display
The following image shows the screen layout.
live audio channel enabled
audio channel disabled
digital zoom on (yellow) / off
USB flash drive connected
key lock on
sequence mode
recording mode
administrator logged on
Note that actual screen icons might differ slightly from the ones shown above.
V. 03 - 17/01/2012
CCTVPROM11
and enter the password of the desired user profile.
LAN connected / Internet connected / no network connection
) or regular user (
or ). The lock-icon (
) during set-up to use the VGA output.
A system date and time
B general system status
C available HDD capacity
D channel status
playback audio channel enabled (yellow)
timer recording
USB mouse connected
Hard disk overwrite (default)
PTZ mode
motion mode
alarm mode
operator logged on
8
). An icon is shown in the
) is now displayed.
) on the front panel
©Velleman nv