Remote Control Operation; Battery Installation - Grundig GSB 910 SW Bedienungsanleitung

OPERATION
7
Disconnected the bluetooth on the smart phone
to switched off the bluetooth connection.
Note:
Bluetooth connection range in 10 meters
7
The model ''Grundig Soundbar 2.1'' in your
7
device was not deleted.
In bluetooth mode, »
7
–
» « etc. are also active.

Remote control operation

1
Insert the batteries into the remote control.
2
Point the remote control at the remote sensor on
the front panel.
3
The sound base is in searching bluetooth signa
status.
4
The remote control works within a distance of
about 8 metres from the sensor and within an
angle of about 30 degrees from the left and
right side.

Battery installation

1 Remove the battery compartment cover on the
back of the remote control.
20 ENGLISH
------------------------------------------------------------------------------------------------------------------------------
II«, »
e «, » «, »
Grundig Soundbar 2.1
2
Load one AAA/1.5V battery into the battery
compartment making sure that the battery have
been inserted with the correct polarities match-
ing the symbols +, - as indicated inside the bat-
tery compartment.
+
«,
3 Replace the cover.
Note:
Remove the battery when you do not intend
7
to use the remote control for a long time.
Weak batteries can leak and severely dam-
7
age the remote control.
The battery must not be exposed to exces-
7
sive heat source, such as sunshine, fire or any
other things like that.
Be environmentally friendly and dispose of
7
batteries according to your government reg-
ulations.