Philips HC8900 Handbuch Seite 6

XP SBC HC 8900/00-1.1
Controls
Transmitter (figure 1)
1 Power indicator – lights up when audio
signals are detected at the audio input.
– starts blinking if the audio signals at the
input are too strong: set the input selector
switch to 3 V or reduce the audio volume
of the audio source.
2 Recharging indicator – lights up when
headphone is replaced on the
FM transmitter. Completely flat batteries
will be fully charged after about 16 hours.
3 Recharging contact – make sure you
align your headphone to this contact for
recharging.
4 DC power – connect to the 12 Volt/200
mA AC/DC adapter
5 3.5 mm stereo headphone audio
input – connects your FM transmitter to
an audio source
6 Input selector switch – select 250 mV
input if connected to a line output of an
audio source
– select 3 V input if connected to a
headphone output of an audio source
7 Channel switch – select one of
7 channels for best reception.We advise
you to select channel 1 as a first option.
8 Controls plate
Environmental Information
All redundant packing material has been omitted.We have done our best to make the
packaging easily separable into two materials: cardboard and polyethylene
Your unit consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment.
6
16-08-2001 15:30
9 Power indication – lights up when in use.
10 Power On/Off – push the button to
11 SRS™ indication – lights up when the
12 SRS™ On/Off – push the button to
13 Recharging contacts – align headphone
14 Recharging indicator – lights up when
15 Volume – adjust volume to your desired
16 Tuning – press and hold the button for
Pagina 6
Headphone (figure 2)
When batteries are low, the power
indicator flashes, and you should recharge
the headphone for about 16 hours before
the next use.
switch the headphone on/off.
SRS™ surround sound mode is activated.
switch the SRS™ surround sound mode
on/off.
to the transmitter, green recharging LED on
the transmitter's front must switch on,
indicating that the headphone is being
recharged.
headphone is replaced on the
FM transmitter. Completely flat batteries
will be fully charged after about 16 hours.
listening level.
about 1 second.The headphone
automatically tunes to the right transmission
frequency. If not, repeat this step.