AEG L 75480 WD Benutzerinformation Seite 31

Problem
The appliance fills
with water and
drain immediately.
The cycle is short-
er than the time
displayed.
The cycle is longer
than the time dis-
played.
The washing re-
sults are not satis-
factory.
The appliance
does not dry or
does not dry cor-
rectly.
There is a big
quantity of fluff in
the drum.
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
service centre.
Possible cause
The end of the drain
hose is too low.
The appliance calculates
a new time according to
the laundry load.
An unbalanced laundry
load increases the dura-
tion time.
The detergent you used
was not sufficient or cor-
rect.
You did not remove the
stubborn stains before
you wash the laundry.
Incorrect temperature
was set.
Too much laundry load.
The water tap is not
turned on.
The drain filter is clog-
ged.
There is too much laun-
dry in the drum.
You have set a wrong
dryness level or drying
time.
Possible solution
Make sure that the drain hose is
in the correct position.
See the 'Consumption Values'
chapter.
This is a normal behaviour of
the appliance.
Increase the detergent quantity
or use a different one.
Use special products to remove
the stubborn stains.
Make sure that you set the cor-
rect temperature.
Decrease the laundry load.
Turn the tap on.
Clean the drain filter.
Reduce the laundry load.
Set additional drying time.
The fabrics washed in the previ-
ous cycle released fluff of a dif-
ferent colour:
• The drying phase helps to
eliminate some fluff.
• Clean the clothes with a fluff
remover.
In case of an excessive amount
of fluff in the drum run the spe-
cial programme to clean it (refer
to "FLUFF IN THE FABRICS" for
more details).
If the display shows other alarm codes,
contact the service centre.
ENGLISH
31