User Manual - Velleman VTHD02 Bedienungsanleitung

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal
waste; it should be taken to a specialized company for recycling. This device should be
returned to your distributor or to a local recycling service. Respect the local environmental
rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, don't install or use it and contact your dealer.
2. Contents
1 x electric drill with on/off
switch
1 x 230 VAC power supply
10 x grinder stone
20 x diamond bit
2 x connective post
3. General Guidelines and Safety Instructions
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
Damage caused by disregarding certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for the ensuing defects or problems.
Familiarize yourself with the functions of the device before actually using it. Do not permit operation
by unqualified people. Any damage that may occur will probably be due to unprofessional use of the
device.
Only use the device for its intended purpose.
Do not press the spindle lock when the device is in use.
Do not touch the bit during use.
Do not use the device if the housing is too hot.
Keep the work area clean.
Protect this device against rain and moisture.
Do not wear baggy clothes as the device's moving parts may get caught in them.
Do not use the device in a dusty environment and near flammable liquids or substances.
Keep this device out of reach of children.
The ON/OFF switch must be off when you plug in the device.
Never use the device without safety goggles.
Store the device in a cool environment.
Check the device for damage prior to use and replace damaged parts if necessary.
Always disconnect the device from the mains when it is not in use or when you wish to clean it. Only
handle the power cord by the plug. Never pull out the plug by tugging the power cord.
Do not crimp the power cord and protect it against damage from sharp edges. Ask an authorised
dealer to replace the cord if necessary.
All accessories should be tested for at least the speed indicated on the tool label. Accessories that
exceed their rated speed can fly apart and inflict injuries.
4. Operation
To use the VTHD02 with its accessories, press the
spindle lock button and unscrew the collet. Insert an
accessory and screw the collet by turning in a clockwise
direction until tight.
V. 02 – 16/05/2013
VTHD02

USER MANUAL

1 x nylon brush
1 x brass brush
1 x steel brush
5 x cutting disc
4 x polishing wheel
6 x sanding band
3
4 x drill bit (1, 2.2, 2.9, and 3.1 mm)
4 x collet
1 x engraving bit
1 x whetstone.
©Velleman nv