Safety Information - EINHELL BT-TW 150 Aufbauanleitung

Anleitung_BT_TW_150_SPK1:_
GB
Important.
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety information with due care. Keep this manual in
a safe place so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and the safety
information as well.
We cannot accept any liability for damage or
accidents which arise due to a failure to follow these
instructions and the safety information.

1. Safety Information

CAUTION
Read all the safety regulations and instructions.
Any errors made in following the safety information
and instructions set out below may result in serious
injury.
Keep all safety regulations and instructions in a
safe place for future use.
Additional safety instructions:
When loading and unloading the drawers, ensure
that the tool trolley and the drawers are evenly
loaded.
It is prohibited to transport persons with the tool
trolley.
Apply the break when loading and unloading.
On slopes or uneven floors ensure that the tool
trolley does not topple.
When moving the trolley on slopes, hold it by the
handle.
Make sure that the maximum total load is not
exceeded. (150 kg)
2. Machine description and items
supplied (Fig. 1/2)
1. Tool trolley
2. Keys
3. Wheels
4. Emergency release
5. Lock
6. Handle
7. Support
8
29.06.2011 12:45 Uhr Seite 8
3. Starting up
The keys (2) for the tool trolley (1) are in two
different places. One is attached to the packaging
of the tool trolley, the other to the instructions for
the tool trolley.
Please keep the keys safe in different places, but
NEVER in the tool trolley.
After transportation and/or assembly make sure
that all drawer compartments are completely
closed.
For safety reasons the tool trolley is equipped
with pull-out stops for the drawers. This prevents
several drawers being opened at the same time.
4. Assembly
Important. To avoid malfunctions, please note
that all the drawers must be COMPLETELY closed
before you pull one out!
The handle (6) supplied with the equipment is
already fitted but can also be mounted on the
other side of the trolley (Fig. 2).
For details of how to mount the wheels (3), please
refer to Figure 3 and turn the tool trolley on its top.
Fasten each of the 4 wheels with a screw, a
spring washer and a standard washer to the tool
trolley.
If problems arise with the drawers, please refer to
the following instructions:
What to do if,
a drawer cannot be closed properly:
Open a second drawer and then close both
drawers simultaneously or
Activate the emergency release (4). This is done
by moving the emergency release on the
underside of the tool trolley. This will release the
lock on the tool trolley (see Figs. 4 - 6).
none of the drawers can be opened, although the
lock is not locked:
Lock and unlock the lock until you hear a loud
"click".
Activate the emergency release (4) (see Figs. 4 -
6).