Adjusting The Time - Siemens VDO MTCO 1324 Betriebsanleitung

Adjusting the time

• The function TIME ADJUSTMENT may
only be selected if the vehicle is station-
ary.
• For an automatic synchronisation of the
chart carrier and the time, the ignition
has to be switched on and there must
not be any chart inserted in the
MTCO.
 Select the TIME ADJUSTMENT via
 Activate the minutes counter via
the minutes start to flash.
 Depress
or
is being displayed.
 Activate the hours counter via
start to flash.
 Depress
or
is being displayed.
½ When exceeding or undershooting 12 p.m.,
the date will be adjusted automatically.
 Acknowledge the time adjustment by depressing
the key for more than 2 seconds. The basic
display will then be shown again.
Comment
If you adjust the time while a chart is inserted, the er-
ror symbol will be shown in the display and the time
will be flashing. The MTCO will remind you to update
the chart carrier settings; ➥ see page 34.
© Siemens VDO Automotive AG
.
or
key until the desired value
, the hours
key until the desired value
= Depress key shortly
= Depress key for a longer interval
,
31