Specifications - Makita 4157KB Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Lever
2-1. Bevel scale plate
2-2. Knob
3-1. Base
3-2. Adjusting screw
4-1. Triangular rule
5-1. Notch
5-2. For 45 ﾟ bevel cuts
5-3. For straight cuts
6-1. Lock-off button

SPECIFICATIONS

Max. cutting capacities
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Do not use the tool upside down.
･
Do not use the abrasive cut-off wheel.
･
Do not use the saw blade and diamond
wheel with grooves and openings.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible recycling
facility.
Explanation of general view
6-2. Switch trigger
7-1. Dust box
7-2. Screw
8-1. Hex wrench
8-2. Shaft lock
9-1. Diamond wheel
9-2. Outer flange
9-3. Hex socket head bolt
9-4. Inner flange
10-1. Rip fence (Guide rule)
Model
Wheel diameter
90°
45°
-1
)
Overall length
Net weight
Safety class
equipment
END206-3
Intended use
The tool is intended for cutting in brick and concrete
without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.31 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
and its
a fuse or protective circuit breaker having slow tripping
characteristics.
3
11-1. Dust cap
11-2. Rubber cap
11-3. Lever
12-1. Rear handle
12-2. Front grip
12-3. Base
13-1. Limit mark
14-1. Brush holder cap
14-2. Screwdriver
4157KB
180 mm
58 mm
29 mm
5,800
354 mm
5.6 kg
/II
ENE024-1
ENF002-2
ENF100-1