Power Connection; English - Kärcher BDP 50/1500 C Bedienungsanleitung

Safety notes for disc one disc machines
Please read and comply with
these safety instructions prior
to the initial operation of your appliance.
Retain these safety instructions for use for
future reference or for subsequent posses-
sors.
Please read the operating instructions
–
for your machine before using it, and
pay particular attention to the following
safety instructions.
Warning and information plates on the
–
machine provide important directions
for safe operation.
Apart from the notes contained herein
–
the general safety provisions and rules
for the prevention of accidents of the
legislator must be observed.

Power connection

The voltage indicated on the type plate
–
must correspond to the voltage of the
electrical source.
Safety class I - Appliances may only be
–
connected to sockets with proper earth-
ing.
While working with fluids (such as de-
–
tergents), we recommend the use of a
safe socket with overcurrent protection
switch (max. 30 mA).
Please use the mains cable prescribed
–
by the manufacturer; the same is also
applicable when you replace the ca-
bles. See Operating Instructions Manu-
al for Order Number and Type.
Check the power cord with mains plug
–
for damage before every use. If the
power cord is damaged, please arrange
immediately for the exchange by an au-
thorized customer service or a skilled
electrician.
The appliance may only be connected
–
to an electrical supply which has been
installed by an electrician in accordance
with IEC 60364.
Operating procedures create short term
–
power sinkings.
During unfavorable net conditions other
–
devices might be disturbed.
With a net impedance lower then 0,15
–
Ohm no disturbances are to be expect-
ed.
Never touch the mains plug with wet
–
hands.
Make sure that the power cord or exten-
–
sion cables are not damaged by run-
ning over, pinching, dragging or similar.
Protect the cable from heat, oil, and
sharp edges.
The power cord must be checked regu-
–
larly for damages, such as cracks or ag-
ing. If damage is found, the cable must
be replaced before further use.
If couplings of the power cord or exten-
–
sion cable are replace the splash pro-
tection and the mechanical tightness
must be ensured.
Prior to any work on the appliance (e.g.
–
brush replacement, installation of ac-
cessories) the mains plug must be dis-
connected.
Do not clean the appliance with a water
–
hose or high-pressure water jet (danger
of short circuits or other damage).
– 1

English 7