Command Mode; Operation - Velleman HAA86C Bedienungsanleitung

4. Command Mode

00 Card-+-PIN-Code Mode
01 Card-Only Mode
02 Card-Only or Key-Press Mode
03 Free-Access Mode
04 Alarm Armed (ON)
05 Alarm Disarmed (OFF)
1 Add Single Access Card
2 Delete Single Access Card
3 Add a Group of Cards
4 Delete a Group of Cards
Remark : the codes in the command mode should be preceded and followed by a # e.g. #00#, #01#, etc.

5. Operation

Press **123456 to activate the command mode. The initial numeric code (factory setting) is 123456. All examples in
this manual use 123456 as their numeric code. Enter #71# if you wish to change the numeric code. Note that the
operation of the keys is audible.
Remarks:
• Enter **123456 (or ** followed by your own numeric code) to enter the command mode. You will hear three beeps
in rapid succession and the LED will momentarily come on (green). Press #9 to exit the command mode. The two-
colour LED turns green as soon as you have entered the numeric code and remains lit for ± 10 seconds. You will
have to start the procedure again if you wait longer than 60 seconds before typing in the next command. Enter # *
# and start over if the operation is interrupted.
a. Selecting the Door-Opening Mode:
- Card-+-PIN-Code Mode
- Card-Only Mode
- Card-Only Mode or Key-Press Mode : # 02 #
- Free-Access Mode
Each successful operation is announced by the LED (green) and by a short and a long beep. The device will still
beep if the operation fails, but in this case the LED does not come on.
b. Connecting the HAA86C with an Alarm/ Disconnecting it
- Alarm signal output
- Deactivating the alarm signal
c. Deleting All Access Codes
d. Adding Access Card(s)
- Add single card
Note : you can add just one card/card number, press # and press #9 to exit. You can also add a group of
cards as follows:
HAA86C_v3
: # 00 #
: # 01 #
: # 03 #
: # 04 #
: # 05 #
# * #
: Press # 1 and hold the card next to the reader or enter the complete card number (6
digits). Next, you should enter ##9.
*# Delete All Access Codes
51 Set Alarm Output Time (1 ~ 254s)
52 Set Door Delay Close Time (1 ~ 255s)
54 Enable Beeper (ON)
55 Disable Beeper (OFF)
6 Set Door Open Time (1 ~ 254s)
71 Modify Password
72 Set Common PIN Code
9 Exit
3 VELLEMAN