Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Maintenance, Lubrication and Care
To ensure proper functionality and a long lifetime, diligent maintenance is
essential.
For operating pneumatic tools, clean air is required. Corrosion residues, dust
and dirt from the pneumatic pipes reduce the efficiency of the tool and will
cause technical problems. An upstream maintenance unit consisting of filter
and pressure regulator valve removes moisture and dirt from the air and
controls the working pressure.
If possible, only use compressed air hoses for the air supply that previously
have not been used with other air tools which required an oil-fog lubrication
system.
After use, clean the device and the accessory with a moist cloth. Do not use
abrasive or aggressive chemicals as benzene or thinner, which may dissolve
plastic parts.
Do not allow liquids to enter the air tool and never immerse it into liquids.
Water in the compressed air inlet can damage the machine. Therefore it is
recommended to drain the air lines and the compressor in regular intervals!
Also clean the air filters in regular intervals.
Oil or lubricate the moving parts of the air tool's trigger mechanism in regular
intervals.
Air Pressure and Air Volume
Operate the air tool with the pressure of 6 bar using a compressor with an air
suction capacity of at least 200 l/min. When using higher pressure than the
max. permitted pressure of 8 bar for operating the air tool, its self life will be
reduced drastically. The ideal capacity is provided by compressors with a
suction capacity of 300 – 400 l/min.
Only use air hoses with an inner diameter of at least 9 mm. When setting up
the air pressure, always keep in mind that the pressure will decrease by
approx. 0.6 bar when using a 10 m long hose with an inner diameter of 9 mm.
Storing
Store the device and all parts of the set indoors in a dust and dirt-free location.
Maintenance and Care
11
Werbung
Inhaltsverzeichnis
