Maintenance And Cleaning; Technical Data - Conrad 97 52 27 Bedienungsanleitung

Handling
• Only use in dry indoor locations. The product must not get damp or wet! There is
a risk of a life-threatening electric shock!
• Never use the product immediately after it has been taken from a cold room to a
warm one. The condensation that forms might destroy your unit. This might cause
a lethal electric shock!
Allow the product to reach room temperature, before connecting it to the power
supply and putting it in to use. This may take several hours.
• Any maintenance or repair work may only be performed by an authorised repair
shop.
• Check the product for damage before each use!
If you detect any damage, DO NOT connect the product to the mains supply!
It can be assumed that safe operation is no longer possible if:
- the product shows visible signs of damage,
- the product does not function or does not function properly (e.g. a burning smell)
- the product was stored under unfavourable conditions
• When setting up the product, make sure that the cables are neither kinked nor
pinched.
• If the product is not to be used for a while (e.g. during storage), unplug the power
cable from the mains socket.
• Avoid the following adverse conditions at the installation location and during trans-
portation:
- Damp or excess air humidity
- Extreme cold or heat
- Dust or flammable gases, fumes or solvents
- Strong vibrations

Maintenance and Cleaning

The product does not require any maintenance. You should never take it apart.
Use a clean, dry, soft cloth for cleaning. Do not apply too much pressure on the housing, this
could result in scratch marks.
Dust can easily be removed using a clean long-haired brush and a vacuum cleaner.
Do not use abrasive cleaning agents, cleaning alcohol or chemical solutions, since
these could damage the housing or even impair operation.
Disposal
Please dispose of the device when it is no longer of use, according to the current sta-
tutory requirements.

Technical Data

a) PoE Injector
Standards: ............................................IEEE802.3af, IEEE802.3at
Network input: ......................................RJ45, 10/100
Network output: ....................................RJ45, 10/100, with PoE
Output voltage: ....................................48V dc
Max. rated output power:......................25-30W (depending on the length of the network cable)
Recommended cable for PoE:..............Minimum CAT5e
Dimensions (W x H x D): ......................Approx. 102 x 75 x 23mm (L x W x H)
Weight: ................................................approx. 192g
Ambient temperature: ..........................0°C to +50°C
Ambient air humidity: ............................10 to 90% relative air humidity (not condensing)
b) Power adaptor
Operating voltage: ................................100-240V~, 50/60Hz
Output:..................................................48V dc, 0.83A
IEEE802.3 10BaseT, IEEE802.3u 100BaseT
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240
Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or
the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2010 by Conrad Electronic SE.