Hama 00042542 Bedienungsanleitung Seite 9

L L Audio Level Limiter
Connection :
When you install the audio level limiter for the first time, make sure that it is swit-
ched off. If it is not, switch the ON / OFF switch to the OFF position.
Connect the power supply plug to the DC 12V / 150mA audio level limiter socket.
Plug the power supply unit into a 230 volt socket.
Before connecting the audio level limiter, the signal source (satellite receiver,
DVB-T receiver, set-top box, etc.) is typically connected to the TV set using a
scart cable. Disconnect the scart cable from the TV set and connect it to the
Scart IN port of the audio level limiter. Connect the scart connector of the audio
level limiter with a scart socket of your TV set.
You can use the AUDIO OUT sockets for simultaneous connection of a stereo
unit, wireless headphones, etc.
Set the switch of the audio level limiter to the ON position; the Power status indi-
cator lamp lights red. Set the rotary level regulator of the audio level limiter to
the medium position of the setting range.
Select the scart socket of the TV set to which the audio level limiter is connected
as input. If the connected signal source supplies a switching voltage, it is trans-
ferred from the audio level limiter to the scart socket of the TV set. Many TV sets
automatically switch to the respective scart socket if a switching voltage is
detected there.
Now switch through the channels of the signal source (such as your satellite
receiver) and check if the volume level is set to your liking. If some channels are
still too loud, reduce the threshold with the LEVEL regulator. If the overall volume
is too low, increase the set volume threshold. Change the volume level slowly
and at small increments until you reach the desired setting. The LEVEL LED only
lights when the volume of the audio signal exceeds the level set on the limiter.
After you switch the audio level limiter on, the Level LED function starts with a
delay of about 30 seconds.
8