Inhaltsverzeichnis
Werbung
D'autres réparations que celles précédemment décrites devront
uniquement être effectuées par un spécialiste autorisé !
Caractéristiques techniques
Tension de fonctionnement ............: 12 VDC
Consommation de courant ............: 60 A max.
20 mA par raccordement REM
Fusibles ..........................................: 3 x 20 A fusible plat automobile
Sensibilité à l'entrée .......................: 350 mV
Impédance d'entrée .......................: 10 kohms
Puissance de sortie........................: 4 x 75 W / 4 ohms
Réponse fréquentielle ....................: 10 - 30.000 Hz
Facteur de distorsion .....................: < 0,2 %
Ratio S/N........................................: 70 55 dB(A)
Division du canal ............................: 50 55 dB
Diviseur subwoofer
Fréquences de division ..................: 30 / 60 / 90 / 120 Hz
Pente du signal ..............................: 12 dB/oct.
Equilibreur
Fréquences médianes....................: 60 / 150 / 400 / 1k / 2,4k / 6k / 15kHz
Régulateur de niveau .....................: +/- 12 55 dB
Subwoofer LINE-OUT
Level ...............................................: 1.5 V RMS / 10 kOhm
70
4 x 110 W / 2 ohms
2 x 220 W / 4 ohms
Introduction
GB
Dear Customer,
We thank you for your purchase of the Car amplifier.
With this car amplifier, you have acquired a product which has been designed to the
latest technological standards.
This product is interference-suppressed. The product thus fulfils the require-
ments of applicable European and national directives. Conformance to these
has been proven; the relevant statements and documents are lodged with the
manufacturer.
To maintain this condition and to guarantee safe operation, the user must observe
these operating instructions!
When queries arise, consult our technical specialists:
Germany: Tel. +49 (0)180 5 31 21 18
Mon. - Fri. 08.00 to 18.00
Austria: Tel. +43 (0)72 42 20 30 60
Mon. - Thu. 08.30 to 12.00, 13.00 to 16.00
Fri. 08.30 to 12.30
Switzerland: Tel. +41 (0)848 87 78 11
Mon. - Thu. 08.00 to 12.00, 13.00 to 17.00
Fri. 08.00 to 12.00
Intended use
The intended use of the Car Amplifier is the processing and amplification of low-lev-
el audio signals in motor vehicles.
This product is only for connection to a 12 V DC vehicle supply with connection of
the negative terminal of the vehicle battery to chassis allowed and may only be built
into and put into service in private and commercial vehicles with this type of supply.
Never connect the unit to a 230 V AC supply.
Due to the type of installation, the user must ensure that the unit is protected from
humidity and moisture.
Any other use than as described above can lead to damage to this product; in addi-
tion, this is accompanied by dangers such as for example short circuit, fire, electric
shock etc.
No part of the product may be modified or converted nor may the case be opened!
The safety information must be observed !
27
Werbung
Inhaltsverzeichnis
