Technical Data - Grundig APOLLO 2000 Handbuch

12
INFORMATION
These loudspeakers are noise-suppressed according to the applicable EC directives.
This product fulfils the European directives 89/336/EEC, 73/23/EEC and 93/68/EEC.
This device conforms to the safety regulation DIN EN 60065 (VDE 0860) and therefore
the international safety regulation IEC 60065.
The type plate with details on the mains supply is located on the side of the bass
loudspeaker casing.
The radio certification details are located on the bottom of the loudspeakers.

Technical data

Amplifier unit
Output: 200 W sine, 360 W music
Input level: 500mV / R (G) 2.2 kΩ
Direct impedance: > 47 kΩ
Frequency response: 20 ... 20 000 Hz
Receiver unit
Reception range: 863...865 MHz
Important notes for users in the U.K.
Mains plug
This apparatus is fitted with an approved moulded 13
Amp plug. To change a fuse in this type of plug
proceed as follows:
1 Remove fuse cover and fuse.
2 Fix new fuse which should be a BS1362 5 Amp,
A.S.T.A. or BSI approved type.
3 Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it
should be cut off and an appropriate plug fitted in its
place. If the mains plug contains a fuse, this should
have a value of 5 Amp. If a plug without a fuse is
used, the fuse at the distribution board should not be
greater than 5 Amp.
Note:
The severed plug must be disposed to avoid a
possible shock hazard should it be inserted into a
13 Amp socket elsewhere.
_____________________________________________________________
System
Operating voltage: 230 V~
Mains frequency: 50/60 Hz
Max. power consumption: 450 W
Power consumption in Stand-by: < 2 W
Dimensions:
W x H x L 56 x 97 x 32 cm
Weight: 19.6 kg
How to connect plug
The wires in the mains lead are coloured with the
following code: blue = neutral (N), brown = live (L).
As these colours may not correspond with the colour
markings identifying the terminals in your plug,
proceed as follows:
1 Connect the blue wire to the terminal marked N or
coloured black.
2 Connect the brown wire to the terminal marked L
or coloured red.
3 Do not connect either wire to the earth terminal in
the plug, marked E (or e) or coloured green (or
green and yellow).
Before replacing the plug cover, make certain that the
cord grip is clamped over the sheath oft the lead – not
simply over the two wires.