Herunterladen Inhalt Inhalt Diese Seite drucken

Using Convenient Functions - Yamaha AV-S77 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 86
You can use convenient functions with the remote control
during audio reproduction.
POWER
MENU LEVEL
C
B
NIGHT
INPUT
B. BOOST
A
POWER
CH
q
TITLE
1
s
5
t
CODE SET
DVD
Å Enhancing the bass tones
Press B. BOOST.
• "B. Boost ON" appears in the display.
• This function enhances the bass tones by increasing
the level of the low-range frequencies.
To cancel B. BOOST mode, press B. BOOST again.
y
• The B. BOOST mode does not function when the headphones are
connected.
• The factory-set is "B. Boost ON".
Note
• If a thudding noise is heard from the subwoofer when this
function is turned on, lower the subwoofer level. Otherwise, the
subwoofer may be damaged due to an excessive input level of
low-bass signal.
24
E-

USING CONVENIENT FUNCTIONS

AV-S77
E
—— MEMORY ——
1
2
3
F
TEST
DISPLAY
EFFECT
MUTE
D
+
ON/OFF
+
h
h
DSP
VOL
g
g
h
TV INPUT
+
TV VOL
TV MUTE
CH
w
+
ENTER
MENU
TV VOL
g
2
3
4
a
d
w
6
7
8
y
e
r
VCR
TV
B. BOOST
ı Listening to music clearly at low
levels
Press NIGHT.
NIGHT
• "Night Mode ON" appears in the display.
• Sounds will be clear.
• Use this function when it is difficult to output high
volumes such as late at night.
To cancel NIGHT mode, press NIGHT again.
y
• The NIGHT mode does not function when the headphones are
connected.
• The volume cannot be decreased using this button. To decrease
the volume, press VOLUME – (or VOL – on the remote control).
• The factory-set is "Night Mode OFF".
Ç Adjusting the level of the subwoofer,
center channel and left and right
rear channels
While listening, you can adjust the sound output level of the
subwoofer, center channel and left and right rear channels as
desired.
1
Select the channel to be adjusted using
LEVEL.
Each time you press LEVEL, the channel is selected in
the following order; SWFR → Center → REAR-L →
REAR-R.
• The channel that can be adjusted will vary depending
on headphones connection or selected DSP program.
2
Adjust the sound output level by pressing +/–.
To decrease
the level.
y
• The sound output level can be adjusted in the following range.
Subwoofer: –20 to +6 dB
Center channel: –20 to +3 dB
Left and right rear channels: –20 to +6 dB
Rear virtual channels (when VIRTUAL SURROUND or
SILENT CINEMA is selected): –3 to +3 dB
• When the sound output level is adjusted, the level adjusted with
the test tone is canceled.
• We recommend that you adjust the channel level using the test
tone beforehand, except the subwoofer.
• When playing back a Dolby Digital or DTS source, the sound
output level of each channel should usually be adjusted to ±0 dB
or below.
+
To increase
the level.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis