Setting Peak Or Trace Mode; Selecting The Target Torque Value - Westfalia RJ-7521 Bedienungsanleitung

To manually turn off the digital torque adaptor
press and release the Power button (2) again.
Setting "Peak" or "Trace" Mode
1. Peak
Press and release the "Peak/Trace" button (4)
when the Digital Torque Adaptor is switched on.
The LCD panel shows "PtoP". After two seconds
the panel shows "0.0". Using the "Peak" mode
the system will display and hold the peak torque
value.
2. Trace
Press and release the "Peak/Trace" button (4)
once more. The LCD panel shows "trACE". After
two seconds the panel shows "0.0". In "Trace"
mode the system will always display the current
torque value.
Selecting the "Target Torque Value"
1. Switch on the unit by pressing the Power
button (2).
2. Use the +button (7) resp. -button (8) to set up
the desired torque value. The value will go up
from 40 Nm to 200 Nm. If you press and hold
the + or - button the value will increase / de-
Using
14