Inhaltsverzeichnis
Werbung
Referenzen
<DME4io-C>
METERING POINT
Signal Delay
CobraNet Latency: 5.33msec
CobraNet Latency: 2.67msec
CobraNet Latency: 1.33msec
Eigenschaften der Eingänge/Ausgänge
ANALOG INPUT CHARACTERISTICS
Input Terminals
<DME8i-C>
CH INPUT 1–8
<DME4io-C>
CH INPUT 1–4
ANALOG OUTPUT CHARACTERISTICS
Output Terminals
<DME8o-C>
CH OUTPUT 1–8
<DME4io-C>
CH OUTPUT 1–4
DIGITAL INPUT & OUTPUT CHARACTERISTICS
Terminal
CobraNet
46
DME8i-C/DME8o-C/DME4io-C Bedienungsanleitung
INPUT 1–4
OUTPUT 1–4
PARAMETER
GAIN
Actual Load
Impedance
–60dB
3kΩ
+10dB
*1.In these specifications, 0dBu is referenced to 0.775 Vrms.
*2.All AD converters are 24-bit linear, 128-times oversampling (Fs=48kHz)/64-times oversampling (Fs=96kHz).
*3.+48V DC (Phantom power) is supplied to CH INPUT EUROBLOCK connectors via each individual software
controlled switch.
Actual Source
Impedance
75Ω
*1.In these specifications, 0dBu is referenced to 0.775 Vrms.
*2.All DA converters are 24-bit linear, 128-times oversampling (Fs=48kHz)/64-times oversampling (Fs=96kHz).
Format
CobraNet
*1.PRIMARY,SECONDARY
*2.Double Channel format and Single format are supported at 96kHz.
CONDITIONS
PEAK red LED:ON
SIGNAL green LED:ON
CONDITIONS
ANALOG INPUT to ANALOG
OUTPUT@96KHz
For Use With
Nominal
Nominal
–60dBu
(0.775mV)
50–600Ω Mics &
600Ω Lines
+10dBu
For Use With
Nominal
Nominal
600Ω Lines
+4dBu (1.23 V)
Data length
16/20/24bit
MIN
TYP
–3
–40
MIN
TYP
6.12
3.45
2.12
Input Level
Max.before clip
–40dBu
(7.75mV)
+30dBu
(2.45V)
(24.5V)
Output level
Max. before clip
+24dBu(12.28V)
Level
100Base-TX
MAX
UNITS
dBFs
dBFs
MAX
UNITS
msec
msec
msec
Connector
EUROBLOCK
(5.08mm pitch)
Connector
EUROBLOCK
(5.08mm pitch)
Connector
RJ-45x2 *1
Werbung
Inhaltsverzeichnis
