White Balance Adjustment - JVC RM-LP55 Bedienungsanleitung

OPERATION (continued)
MENU
FILE
WIDE
WHITE PAINT
R
L
o WHITE BALANCE ADJUSTMENT
●
Auto white balance adjustment
1.
Set the white balance mode to AAUTO1B or
AAUTO2B.
WHITE BALANCE
PNT OFF AUTO1
2.
Shoot a white subject (white paper, white wall,
etc.) so that it fills the whole screen.
3.
Press ENTER/SET button E.
Enters the auto white
balance mode.
AUTO WHITE 1
● AAUTO WHITE 1 (or AUTO WHITE 2)
OPERATIONB appears on the LCD. The
camera's auto white balance mode is
activated.
4.
Adjustment ends when AAUTO WHITE 1 (or
AUTO WHITE 2) COMPLETEDB is displayed
on the LCD.
The LCD shows AAUTO WHITE 1 (or 2)B for
●
about 3 seconds and will return to the Menu
item select display (step
AUTO WHITE 1
COMPLETED
E-12
C D E
ENTER
FUNC1 FUNC2
/SET
W.BAL GAIN SHUTTER
H
ZOOM
TELE
SLOW FAST
IRIS
AUTO/MANU
B
ENTER
/SET
OPERATION
1.
).
NOTE:
if the LCD shows ACOLOR BARS WORKINGB,
cancel the color bar and repeat this procedure.
(Auto white balance does not function when the
color bars are on.)
COLOR BARS
Error Messages
If auto adjustment fails, the procedure stops and
one of the following error messages wiil appear on
the LCD.
Light is insufficient.
●
Increase the amount of light or increase the gain.
(AGAIN (SENSITIVITY) SETTINGB (A pg. 13))
AUTO WHITE 1
LOW LIGHT ERROR
Light is too strong.
●
Make sure strong light such as sunlight is not
entering the lens either directly or being reflected
by the object the lens is focused on.
AUTO WHITE 1
OVER LIGHT ERROR
The object used for adjustment purposes is not
suitable.
●
Check to see if the object is too white. (Change
the object if necessary.)
AUTO WHITE 1
OBJECT ERROR
NOTES:
●
The messages above are displayed for about
3 seconds.
●
If AAUTO2B is selected, the display shows an
error message below AAUTO WHITE 2B.
WORKING