Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembly
Remove the transport protector from the keypad (keypad in accessories kit).
Transport
protector
Depending on need, clip the screen or blind covers from behind onto both sides of the keypad.
Screen
Place the frame (1) on the keypad from behind.
As shown in the figure, plug the flat band cable (2) until it engages in the connector of the installation part.
Move the rubber seal (3) until it is flush in the connector of the installation part.
Frame (1)
Do not place the keypad with frame in the
ble all other components of the system and execute a functional test. You
will find all additional information with respect to cabling, functional tests,
start-up, etc. in the installation manual for the SmartKey arming device.
"To avoid damage, the flat cable may only be
bent slightly."
WARNING
After successful conclusion of the functional test, now press the keypad
with the frame into the installation part. The bases of the keypad must en-
gage in the notches of the installation piece.
The keypad with frame can now no longer be removed without damag-
ing the keypad!
Flat band cable (2)
i
nstallation part; instead, first ca-
- 6 -
WARNING
"To avoid damage, the flat cable may
only be bent slightly."
Blind covers
Rubber seal (3)
610-4.998.115.270
A4 01.04.2004
Werbung
