Intended Use; Slacken The Tension Of The Steel Cable - Westfalia 81 19 94 Bedienungsanleitung

Intended Use

 The hand power puller is designed for moving and pulling freely moving
(rolling/swimming/sliding) within the limits that are specified in the technical
data. The hand power puller must not be used for moving fixed loads and for
lifting loads.
 The intended use also includes an operation following the operating instruc-
tions. Any use beyond these parameters (different media, applying force) or
any changes (reconstruction, no original accessory) can lead to serious risks
and is regarded as use that is contrary to the intended purpose.
Before each operation, secure the load against rolling.

Slacken the Tension of the Steel Cable

1. Make sure the safety hook
(5) resp. The safety hook
with the pulley is anchored
to a sturdy point.
2. Lift up the release spring
(1) in direction to the arrow.
3. Lift up the lever (9) and
hold it in this position. Now
the tension of the steel
cable is slackened.
4. Hook one end of the power puller on a rigid
anchoring point and pull the hand power puller
up to the desired length. While unwinding the
steel cable make sure that at least three wind-
ing will remain on the cable drum!
5. Hook the other safety hook (5) on the load to
be pulled and press down the release spring
(1).
Operation
16