Jaws Head; Resistance Measuring - Westfalia 82 23 12 Bedienungsanleitung

release the trigger. Try to place the wire as close as possible to the
middle of the jaws and hold the unit steadily during measuring. The
diameter of the wire to be measured can be up to 28 mm.
Example: DC Current Measuring
5. On the display the current value is displayed. Furthermore you will
see an amplitude in the bar diagram (I) on the bottom side of the
display.
6. Make sure not to exceed the max. measuring range of 400 A!
During measuring you can use the "HOLD" function (9), the "RANGE"
(11) and the "∆ZERO" function (2).

Jaws Head

To achieve accurate measuring
values, keep the wire as close as
possible to the middle of the jaws.
If the wire to be measured is not
placed centrically the measuring
error can be up to 1.5 %.
Resistance Measuring Ω
Attention: Dot not perform resistance measurements on voltage-
carrying components or circuits.
Operation
Example: AC Current Measuring
Marking
Wire
Marking
22