Cleaning And Maintenance - Klarstein 10012195 Bedienungsanleitung

5) Switching off
1. After you are finished cooking, switch off the induction hob by pressing the on/off button; the
display will show „OFFMhefan will still run fora while to cool the appliance.
2. When the fan stops, disconnect the appliance from the power outlet and let it cool entirely.

CLEANING AND MAINTENANCE

Before cleaning and any handling of the induction hob, unplug it from the power outlet and allow the hob
to cool!
Keep the hob out of reach of children until it cools!
After cooling, clean the ceramic glass cooktop and the control panel of the hob with a cloth and use a
cloth moistened with dish detergent for more soiled places.
Do not use abrasive sponges or scouring powder. Do not immerse the induction hob and the power cord
in water!
Keep the top of the hob clean all the time to prevent accumulation of dirt around the fan and its possible
failure. Wipe the dust from the area of air circulation openings using cotton buds or a toothbrush with a
small amount of non agressive cleaning detergent and carefully remove oil stains.
Clean carefully the remnants of cleaning agents off the cooktop with damp cloth, otherwise they can burn
when the hob is turned on.
If the display shows a warning message, follow the instructions below.
Warning Possible cause
An unsuitable pot/pan is on the
E0
induction zone or the diameter of the
pot/pan is less than 12 cm.
Bad connection of the induction hob/
E1
faulty electrical circuit.
Problem with the temperature
E2
sensor.
E3
Voltage is too high.
E4 Voltage is too low.
Protection against overheating -
E5
the cooktop is too hot.
Problem with the fan, the air in-
E6
take/outflow is blocked.
WARNINGS
Solution
Place suitable cookware on the cooktop.
Contact an authorized service center.
Contact an authorized service center.
Check the power source, turn on when the
power source returns to normal.
Check the power source, turn on when the
power source returns to normal.
Wait few minutes until the appliance cools;
check the pot/pan.
When the appliance cools down, clean the
openings. Afterwards, restart the appliance.
If the problem persists, contact an authorized
service center.
9