To Clear Programmed Commands - Sony RM-VZ800T Bedienungsanleitung

Executing a Series of Commands
— System Control Functions
(continued)
Tips for programming the
System Control functions
The following information helps
you to programme a consecutive
operation steps.
About the order of operation
steps
Some of the components may not
accept consecutive remote control
signals. For example, some TVs
generally may not respond to the
next signal right after the Power-
on signal. So, a series of
commands such as TV Power-on
and input select may not work
properly.
In this case, insert other signals to
other components like such as in
the example below:
TV Power-ontVCR Power-ont
VCR playbacktTV input select
Changing the interval between
operation steps
While you are setting a
programme, you can insert a 0.4
second interval before the next
step is executed by pressing the
same Component Select button
again. In the example above, if
you press AMPt1 tAMPt1
in Step 2, you can insert a 0.4
second interval after the AMP
power-on signal is transmitted.
GB
28
To clear programmed
commands
1
Press and while holding
SET, press and hold for
more than 3 seconds the
SYSTEM CONTROL button
you want to clear.