Installation - Klarstein 10028327 Bedienungsanleitung

Preparation
• The installation position of dishwasher should be near the existing inlet and drain hoses and power cord.
• One side of the cabinet sink should be chosen to facilitate the connection of drain hoses of the dishwasher.
Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be
positioned to the right or the left to facilitate proper installation.
Power Cennection
Ensure the voltage and frequency of the power being corresponds to those on the rating plate. Only insert the
plug into an electrical socket which is earthed properly. If the electrical socket to which the appliance must be
connected is not appropriate for the plug , replace the socket, rather than using a adaptors or the like as they
could cause overheating and burns.
Watter Supply Hose
The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be
reused. Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below the minimum consult
our Service Department for advice.
• Connection: Pull The safety supply hoses completely out from storage compartment
located at rear of dishwasher. Turn water fully on before starting the dishwasher. Tigh-
ter the screws of the safety supply hose to the faucet with thread 3/4inch.
• Disconnection: Turn off the water. Unscrew The safety supply 2 hose from the faucet.
IMPORTANT: Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is
fastened tightly in place. If the water pipes are new or have not been used for an extended period of time, let
the water run to make sure that the water is clear and free of impurities. If this precaution is not taken, there is
a risk that the water inlet can get blocked and damage the appliance.
Drain Hose
Insert the drain hose into a drain pipe with a minimum
diameter of 4cm, or let it run into the sink,making sure to
avoid bending or crimping it.
Use the special plastic support that comes with the ap-
pliance. The free end of the hose must be at a height
lower than75cm and must not be immersed in water to
avoid the back flow of it.

Installation

24