Werbung
Verfügbare Sprachen
Verfügbare Sprachen
HEIGHT ADJUSTMENT OF RETAINING GUIDE POLES
(TADE-UP AND SUPPLY SIDES)
© Checking of the take-up and supply sides
1. Making
the cassette tape run, check that the tape is
neither broken nor wrinkled.
See Fig. 71-A.
Retaining
guide pole
Guide roller
The tape must be
Figure 71-A
2. Slowly
rotate
the retaining guide adjusting nut with
a bladed
screwdriver
so
as to satisfy
the specified
value (2 = 32.3570)
mm).
© Adjustment of take-up and supply sides
1. Place the guide height adjusting jig on the guide plate
as shown in Fig. 71-B.
Take-upysupply
retaining
guide pole (adjust nut)
XN
Height adjust-
ing jig
Figure 71-B
Werbung
