Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Protect this device from shocks and abuse. Avoid brute
force when operating the device.
Familiarise yourself with the functions of the device before actually
using it.
All modifications of the device are forbidden for safety reasons.
Damage caused by user modifications to the device is not covered
by the warranty.
Only use the device for its intended purpose. Using the device in
an unauthorised way will void the warranty.
Damage caused by disregard of certain guidelines in this manual
is not covered by the warranty and the dealer will not accept
responsibility for any ensuing defects or problems.
Due to constant product improvements, the actual product
appearance might differ from the shown images.
Product images are for illustrative purposes only.
Do not switch the device on immediately after it has been exposed
to changes in temperature. Protect the device against damage by
leaving it switched off until it has reached room temperature.
Keep this manual for future reference.
4.
Battery
Refer to the illustrations on page 2 of this manual.
Transmitter
1.
Open the transmitter to reveal the battery compartment. Use a
flat-head screwdriver.
2.
Install the CR2032 battery according to the correct polarity.
3.
Close the battery compartment. Proceed with the installation.
Receiver
1.
Open the receiver to reveal the battery compartment.
2.
Install 3 x 1.5 V AA batteries according to the correct polarity.
3.
Close the battery compartment. Proceed with the installation.
Remark: Remove the batteries if the transmitter and receiver will
not be used for a longer period.
V. 04 – 23/04/2019
EDM1/EDMTW/EDMTWR
7
©Velleman nv
Werbung
