Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Software Preparation
(first time only)
The following settings are necessary to prepare the DVD-ROM Drive Pack for use:
(( WJiitifa'JBGOif ) : The following settings are unnecessary.)
1
Add the check mark for [DMA] in [Start] - [Settings] - [Control Panel] - [System]
- [Device Manager] - [CD-ROM] - [MATSHITA DVD-ROM SR-8173] - [Set¬
tings].
2
Set [L:] for both [Start drive letter] and [End drive letter] in [Reserved drive
letters], then press [OK].
3
At the [System Properties], press [OK]. The display will ask you to restart Win¬
dows, select [Yes] to restart.
I
# (WfliTitoYfigH ) (with the FIRSTA1D CD included): When reinstalling, refer to the
above steps 2 - 3 to set the reserved drive letters of the CD-ROM drive.
• When booting up from the FIRSTAID FD (for example, to reinstall the operating
system), the DVD-ROM Drive does not have to be replaced by the CD-ROM Drive
(CF-VCD271). The CD-ROM driver will recognize the DVD-ROM Drive.
Using the DVD-ROM Drive Pack in the MS-DOS mode
(rWlnTiFWBCOir J : It is unnecessary to read this explanation.)
To use the DVD-ROM Drive Pack in the MS-DOS mode, configure the drive following the
steps below after performing the above steps 1 ~ 3. If the steps listed below are per¬
formed without completing steps 1 - 3 above first, the drive will not operate properly.
7 Click the [StartJ button then select [Shut Down],
2
Select [Restart in MS-DOS mode] and click [OK].
3
Open the "CONFIG.SYS" file for editing by issuing the following commands:
edit config.sys
CEnterJ
4
Move the cursor to the line containing "(ATAPICD.SYS*" and
delete the characters "rem" at the beginning of the line. (Deleting "rem" causes
the item to become valid.)
DEVICEH1GH=C:\WINDOWS\COMMAND\ATAPICD.SYS'/D:MSCDOOO
(If this line is missing, add it.)
*ATAP1CD.SYS
OAKCDROM.SYS
Werbung
