Yamaha MT3X Bedienungsanleitung Seite 24

PUNCH-IN/OUT RECORDING
Punch-wout recording makes it possible to re-record a short segment of an otherwise perfect track in order to correct
a mistake or-brush up- an important passage. You -punch-in- at the point where you begin recording the new
sssmen;
so that the previously-recorded material is not erased. The
MT3X AUTO PUNCH I/O function makes this operation easier than ever.
• Manual Punch-in/qut Using the REC SE¬
LECT Switches
1. Start the deck running — a few measures before
the section to be re-recorded begins — in the rec¬
ord-ready mode by pressing the REC button and
then the PLAY button with all track REC SELECT
switches set to OFF. The red REC indicator will
flash indicating that the transport is in the record-
ready mode. The PHONES SELECT switch should
be set to MIX so you can hear all the tracks and the
source you are about to record.
2. At a convenient break in the track switch the track
to be corrected to the record mode (punch-in by
switching the REC SELECT switch for that track to
the appropriate record position) and start playing
the new material to be recorded. The REC indicator
will light continuously as soon as the REC SELECT
switch is set to a record, position.
3. At the end of the re-recorded segment switch the
track back to the play mode (punch-out by switching
the REC SELECT switch for that track to OFF). The
red REC indicator will begin to flash.
• Footswitch Punch-in/out
1. Plug a YAMAHA FS-1 (optional) footswitch into the
MT3X PUNCH I/O jack.
2. Set the REC SELECT switch for the track to be
punched-in to the appropriate record position, and
press the REC button to activate the rec/pause
mode. The red REC indicator should flash instead
of lighting continuously. If the red REC indicator
lights continuously, press the footswitch once so
that it flashes.
3. Press the PLAY button to start the transport running
in the record-ready mode.
4. Press the footswitch to punch-in. The red REC indi¬
cator will light continuously.
5. Press the footswitch a second time to punch-out.
The red REC indicator will begin to flash.
TRACK 1
TRACK 2
TRACK 3 1
TRACK 4
Ail tracks monitored in PLAY¬
BACK mode (the deck is in the
REC mode, but the track REC
SELECT switches are set to
OFF).
1
ST
The record mode is engaged for
track 3 only when the track 3
REC SELECT switch is set to
an ON position.
OP
Begin playback
It's a good idea to actually start playing i
1
little
before the punch-in point.
>
-
23
-