Husqvarna 533RS Bedienungsanweisung Seite 26

Maintenance
Examine the starter and the starter rope for damages.
Examine the spark plug. Refer to
Make sure that the bevel gear is filled to ¾ with grease.
Clean the external surface of the carburetor and the area around it.
Clean the spark plug. Remove the spark plug and do a check of the electrode
gap. Adjust the electrode gap or replace the spark plug if it is necessary. Refer
Technical data on page 29 . Make sure that the spark plug is assembled with
to
a supressor.
Examine the clutch, clutch springs and the clutch drum for wear. Replace if it is
necessary.
Replace the spark plug. Make sure that the spark plug is assembled with a
supressor.
Lubricate the drive shaft.
Make sure that the vibration damping units are not damaged.
Clean the cooling system of the product.
Clean the muffler.
To do a check of the muffler
WARNING:
has a damaged muffler. Always replace a
damaged muffler.
WARNING:
Mufflers with catalytic converters become
very hot during operation.
WARNING:
decreases the noise level and points the
exhaust gases away from the operator. The
exhaust gases are hot and can contain
sparks.
CAUTION:
must be replaced if it is damaged. Do not
use a product if the spark arrester screen on
the muffler is missing or damaged.
CAUTION:
is blocked, the product becomes very hot
and this causes damage to the cylinder and
piston.
1. Make sure that the muffler is not damaged.
2. Make sure that the muffler is correctly attached to
the product.
26
To examine the spark plug on page 27 .
Do not use a product that
Risk of burn injury or fire.
Risk of fire. The muffler
The spark arrester screen
If the spark arrester screen
To adjust the idle speed (533RS)
Your Husqvarna product is made to specifications that
decrease harmful emissions.
1. Make sure that the air filter is clean and the air filter
cover is attached before you adjust the idle speed.
2. Adjust the idle speed with the idle speed screw T
which is identified with "T" mark.
a) Turn the idle speed screw T clockwise until the
cutting attachment starts to rotate. (Fig. 84)
b) Turn the idle speed screw T counterclockwise
until the cutting attachment stops and the noise
from the clutch decreases.
WARNING:
attachment does not stop when you
adjust the idle speed, speak to your
servicing dealer. Do not use the product
until it is correctly adjusted or repaired.
3. The idle speed is correct when the engine operates
smoothly in all positions. The idle speed must be
below the speed when the cutting attachment starts
to rotate.
Note:
Technical data on page 29 for the
Refer to
recommended idle speed.
To adjust the idle speed (543RS,
553RS)
Your Husqvarna product is made to specifications that
decrease harmful emissions.
Daily Weekly Monthly
X
X
X
X
X
X
X
If the cutting
1756 - 002 - 11.12.2023
X
X
X
X