Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PI
2.6. Installing
1. Set the cabinet in its place.
2. Adjust the cabinet to stand perpendicularly using the adjustable legs.
3. Ensure that the airflow to the condenser unit is not obstructed.
When installing the cabinet, make sure of the following:
• The area where the cabinet is placed is flat and level.
• The cabinet is not placed in the immediate vicinity of a heat source
such as a radiator, air blown heater or spotlight.
• The cabinet is not exposed to direct sunlight. If necessary, use blinds in
any nearby window.
• The air conditioning for the premises does not blow onto the cabinet.
The correct positioning of the cabinet optimises temperature conditions and
performance, thus helping save energy and elongate the service life of the
cabinet.
Cabinets with castors / wheels may be anchored to the wall behind them as
a safety precaution.
2.7. Cleaning before use
1. Clean the cabinet surfaces and the storage compartment for foodstuffs with a mild liquid
detergent (pH 6-8) before using the cabinet.
Follow the instructions provided with the detergent.
NOTE
Make sure that all cleaning fluids are classed as non-toxic.
2. Dry the surfaces carefully.
3. Electrical connections
NOTE
The symbol marked on the cabinet (a lightning bolt inside a triangle) indicates
that there are components and wires under the cover containing live voltage.
Only personnel qualified to install and service electrical equipment are permitted
access to areas that contain live voltage.
Check the voltage and size of the fuse required on the rating plate attached to the cabinet. The
supply socket must be earthed and protected by a 10 A slow fuse. No other appliances may be
connected to the same fuse.
NOTE
All electrical connections must be carried out by approved and qualified
personnel and comply with all IEE and local regulations, failure to do this could
result in personal or fatal injury.
Original instructions
ENGLISH
5
Werbung
