Bosch Advanced GrassCut 36V-33 Originalbetriebsanleitung Seite 18

18 | English
ing on the ways in which the machine is used; and of the
need to identify safety measures to protect the operator that
are based on an estimation of exposure in the actual condi-
tions of use (taking account of all parts of the operating cycle
such as the times when the machine is switched off and
when it is running idle in addition to the trigger time).
Mounting and Operation
Action
Product Features
Delivery scope
Mounting the protection guard
Mounting the plant protector
Mounting the kickback protection/
operating advice for right-handers
Mounting the kickback protection/
operating advice for left-handers
Mounting the carrying strap
Battery charging and inserting
Switching on and off
Mounting the cutting line
Line feeding
Removing the spool
Mounting the blade
Working Advice 1
Working Advice 2
Troubleshooting
Brushcutter
Problem Possible Cause
Motor refuses to start Battery discharged
Battery too hot/cold
Battery not fully inserted
Grass wrapped around the spool
Garden tool functions On/Off switch defective
intermittently
Internal wiring of garden tool defective
Cutting head is blocked
Garden tool subject to Grass too high/dense
overload
Poor cutting perform- Garden tool subject to overload
ance
Excessive cutting line
Protection guard encrusted with mud
F 016 L94 403 | (10.11.2022)
Action
Working with the blade
Working with the spool
Storage
Maintenance
Accessories
Pro-Tap
Figure Page
To feed the line simply tap the trimmer spool onto the
A 21
ground. The Pro-Tap system will release approximately
B 22
10 mm of line to each side of the spool.
C 22
If the line has broken off close to the eyelet, tapping should
be repeated a few times in order to cut at the full 33 cm dia-
D 23
meter.
E 24
EasyWind
F 24
The EasyWind spool feature enables line loading without the
need to disassemble the spool.
G 25
In case the spool needs reloading with line:
H 25
– cut off 3m of the cutting line accessory,
– align the arrows on the spool with the line feed button,
I 26
– insert the line through the eyelet marked 'line in' and pull
J 27
it through the other side. Measure an equal amount of line
K 28
on both sides,
L 28
– use the line feed button to wind the line onto the spool by
turning it in an anti-clockwise direction (see arrows on
M 29 − 30
spool) until approximately 10 cm of line is left on each
N 31
side.
O 31
Figure
Corrective Measure
Check the battery charge-control indicator and
charge the battery
Allow to cool/warm
Ensure battery is inserted correctly
Remove battery, then remove grass
Contact Bosch customer service agent
Contact Bosch customer service agent
Remove the cutting head, clear any blockages and
reinsert the cutting head
Cut in stages
Move the device slower
Rewind the line (see figure J) and check the cut-
ting blade
Clean inside of the protection guard
Page
P 32
Q 32
R 33
S − T 33 − 34
U 35
Bosch Power Tools