Putting Into Operation; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL DRS 200/2 Bedienungsanleitung Und Wartungsanleitung

Anleitung_DRS_200_2_SPK1:_
Air quality
cleaned and oiled
Air supply
via conditioning unit with filter pressure reducer
and mist oiler
Compressor capacity
approx. 250 l/min. equivalent to a motor rating of 2.2
kW
Work settings
6 bar working pressure set at the pressure
reducer or filter pressure reducer
Please note:
When working with the ratchet screwdriver, be
sure to wear the necessary protective clothing.
Observe the safety regulations.

5. Putting into operation

Screw the supplied plug-in nipple into the air
connection after you have wound 2 to 3 layers of
sealing tape around the thread. Plug the bit or drive
socket on the square drive (3). Select the correct
direction of rotation at the selector pin. R =
reverse/release screw, F = forward/tighten screw.
Place the drive socket or bit on the nut or screw
head. Press the trigger. The tool is connected to the
air supply by means of a flexible pneumatic hose
with a quick-release coupling. To get the best
performance out of your screwdriver, use a
pneumatic hose with an internal diameter of 10 mm.
6. Maintenance and cleaning
Observance of the following maintenance
instructions will ensure that this quality tool gives you
years of troublefree service. Regular lubrication is
vital for the long-term, reliable operation of your
ratchet screwdriver. Use only special tool oil for this
purpose.
You can choose from the following options for
lubricating the tool:
6.1 By mist oiler
A complete conditioning unit includes a mist oiler and
is fitted to the compressor.
22.01.2009 11:31 Uhr Seite 9
6.2 By hand
Each time before you use your impactscrewdriver,
feed 3-5 drops of special tool oil into the air
connection. If the pneumatic tool has not been used
for several days, you must feed 5-10 drops of oil into
the air connection before you switch on. Keep your
pneumatic tool in dry rooms only.
7. The warranty does not cover:
Wearing parts
Damage caused by an unacceptable level of
working pressure.
Damage caused by unconditioned compressed
air.
Damage caused by improper use or
unauthorized tampering.
8. Cleaning, maintenance and
ordering of spare parts
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
GB
9