Kenwood KM316 Bedienungsanleitung Seite 10

KENWOOD CHEF KM300, 400, 410 / MAJOR KM600, 800, 810
troubleshooting
problem
The whisk or K-beater knocks against the bottom of the bowl or isn't
●
reaching the ingredients in the bottom of the bowl.
solution Adjust the height. Here's how:
●
Unplug.
1
Raise the mixer head and insert the whisk or beater.
2
Hold it, then loosen the nut
3
Lower the mixer head.
4
Adjust the height by turning the shaft. Ideally the whisk/K-beater should
5
be almost touching the bottom of the bowl
Raise the head, hold the whisk/K-beater and tighten the nut.
6
to fit and use your round/D-shaped
splashguard (if supplied)
Raise the mixer head until it locks.
1
Fit the bowl onto the base.
2
Push the splashguard on until fully located
3
should be positioned as shown round
Insert required tool.
4
Lower the mixer head ensuring the splashguard follows the shape of
5
the bowl.
During mixing, ingredients can be added directly to the bowl via the
●
hinged section of the splashguard.
You do not need to remove the splashguard to change tools.
●
Remove the splashguard by raising the mixer head and sliding it down.
6
3
. The hinged section
and D-shaped