Slave Mode - Cameo OTOS SP6 Bedienungsanleitung

Make the settings as desired (see table, select with  and , confirm with ENTER, change value
or status with  and  confirm with ENTER).
Master/Alone
Send to XLR
Master
Send to
W-DMX
Alone

SLAVE MODE

Starting from the main display, press MENU to enter the main menu. Using  and , select the
Control menu item and confirm with ENTER. Then select Slave and confirm again. Activate the
output of the control signal in the master unit (Control -> Stand Alone -> Master/Alone -> Mas-
ter). Connect the slave and master units (same model, same software version) using a DMX cable
or make the connection via W-DMX and activate the Play Scene or Play Loop stand-alone mode in
the master unit. The slave unit will now follow the master unit.
Information on the submenu items in the slave menu and the corresponding setting options can
be found in the table below (select with and , confirm with ENTER, change value or status
with and , confirm with ENTER).
Slave
XLR (permanently active)
On
Wireless Off
Unlink
Control signal is forwarded via DMX OUT
Off Deactivate sending of the DMX control signal via W-DMX
On Activate DMX control signal forwarding via W-DMX
Force to pair Pairing with ready-to-pair W-DMX devices
Unlink All Disconnect all W-DMX connections
Do not forward control signal
Activate W-DMX module
Deactivate W-DMX module
Disconnect all connections and place in pairing standby mode
23