Panasonic EY7410 Bedienungsanleitung Seite 7

● The LED is incapable of lighting
the tip of the bit when the drill is
used in the straight configuration.
 Bit-locking Function
With the switch at off and the bit lock-
ed in place, the tool can be used as a
manual screw-driver - up to 14.7 N·m
(150 kgf-cm, 130 in-lbs).
There will be a little play in the driving
shaft, but this is not a malfunction.
 Main Switch (ON/OFF)
Push the upper half of the switch for
forward rotation, or the lower half for
reverse rotation.
Forward
Reverse
Reverse
 Speed Selector Switch
To suit the application of this tool, two
different rotational speeds are avail-
able. Depending upon use, either the
high or low speed should be select-
ed.
HIGH
Speed selection
LOW 00 /min (rpm)
HIGH 600 /min (rpm)
CAUTION:
 Main Switch Lock
After use, set the main switch lock at
the lock position to prevent accidental
operation.
Main switch lock
 Battery Pack (EY9L10)
CAUTION:
1. Remove the battery pack away from
. Charge the battery pack using the
3. After charging has been completed,
Forward
NOTE:
LOW
Torque
High
Low
- 7 -
• Check speed selector switch before
use.
• Do not operate the speed selector
switch while the main switch is on
(switch is in the ON position).
the tool.
battery charger.
remove the battery pack from the
charger and connect it to the tool.
Disconnect the charger from the
power source when not in use.
Use under extremely hot or cold
conditions will reduce operating
capacity per charge.
Lock