Troubleshooting
PROBLEM
The appliance is
not working. The
On/Off indicator
lamp 0 does
not light up.
The appliance
does not start
cooking.
"
" appears
on one of the
displays t.
"
" appears
on one of the
displays t.
"
" appears
on one of the
displays t.
"
" appears
on one of the
displays t.
"
" appears
on one of the
displays t.
"
" appears
on one of the
displays t.
■
16
│
GB │ IE
POSSIBLE CAUSE
The plug is not connected.
The appliance is damaged.
There is no cooking vessel on the
respective induction field 1/3.
The pot/pan is not suitable for
induction cookers.
The child lock is activated.
There is no vessel on the respec-
tive induction field 1/3 or the
pot/pan is too small.
The pot/pan is not suitable for
induction cookers.
The temperature sensor under-
neath the induction field 1/3
is defective.
The appliance is being supplied
with excessively high voltage
(> 275 V).
The appliance is not being
supplied with enough voltage
(< 150 V).
The temperature sensor beneath
the induction field 1/3 is de-
fective or there is a short circuit.
The electronics have overheated.
POSSIBLE SOLUTIONS
Connect the appliance to a mains
power socket.
Contact the Customer Service
department.
Place a suitable pot/pan on the
respective induction field 1/3.
Use a suitable pot (see the "Suitable
cookware" section).
r and
Hold down the
buttons for about 3 seconds.
Place a suitable pot/pan on the
respective induction field 1/3.
Disconnect the plug from the mains
power socket and contact the Cus-
tomer Service department. Enter the
error code.
Make sure that the appliance is
connected to a properly installed
mains power socket supplying
220–240 V ~ , 50/60 Hz.
Make sure that the appliance is
connected to a properly installed
mains power socket supplying
220–240 V ~ , 50/60 Hz.
Disconnect the plug from the mains
power socket and contact the Cus-
tomer Service department. Enter the
error code.
Check to see whether the fans on
the bottom of the appliance are
working correctly and whether they
can take in a sufficient volume of air.
z
SDI 3500 D5